Atlas 412 12,000 lb Commercial 4-Post Lift

SKU: ATEATTD-412

The Atlas® 412 incorporates many structural and cosmetic features that are found on lifts costing thousands of dollars more money. The Atlas® 412 is tested to ensure that this lift system will perform flawlessly at its rated capacity. The Atlas® 412 has been manufactured to the same exacting specifications for many years.

The Atlas® 412 uses a high strength cable system (with a under runway oversized hydraulic cylinder) powered by a 220 volt (single phase) power unit to raise and lower the lift. Many competitors use an “old style” chain lifting system with an exposed hydraulic cylinder system. Old style chain lifts are difficult to “level” properly and the exposed hydraulic cylinder is responsible for numerous “door dings”.

Finally, the Atlas® 412 features “tracks” between the runways to allow the use of a rolling bridge jack (such as the Atlas® RJ6BK) on the lift. Rolling jacks sold separately.

Atlas® ATTD-412 Specifications
Capacity	12,000 lb.
Lifting Height	77 3/4" (6' 5 3/4")
Overall Width Of Columns (Without Motor)	126 1/4" (10' 6 1/4")
Overall Width Of Columns (With Motor)	135 1/4" (11' 3 1/4")
Overall Length With Approach Ramp	236 1/2" (19' 8 1/2")
Length Between Columns	183 1/4" (15' 3 1/4")
Runway Length	194 1/2" (16' 2 1/2")
Runway Width	20"
Thickness Of Runway	7 1/2"
Width Between Runways	43 1/4" (w/ Rail 39 3/4")
Outside Runway To Outside Runway	83 1/4" (6' 11 1/4")
Clearance Under Runways	70 1/4" (5' 10 1/4")
Clearance Between Columns	112 5/8" (9' 4 5/8")
Height Of Columns	89 3/4" (7' 5 3/4")
Maximum Wheel Base	185" (15' 5")
Drive Thru	98" (8' 2")
Air Requirement	85-115 PSI (EXTERNAL AIR SUPPLY REQUIRED)
Motor/Electrical Requirement	220 volt single (1) phase. A 30 amp breaker is recommended
Oil Requirement	3-5 Gallons AW32/AW46 (NOT INCLUDED)
Shipping Weight	2,800 LBS.
Requires a minimum of 6" of concrete with a 3000 psi. rating